CH341A USB SPI flash programmer with SOIC8 test clip
CH341A USB SPI flash programmer with SOIC8 test clip
CH341A USB SPI flash programmer with SOIC8 test clip
CH341A USB SPI flash programmer with SOIC8 test clip
  1. CH341A USB SPI flash programmer with SOIC8 test clip
  2. CH341A USB SPI flash programmer with SOIC8 test clip
  3. CH341A USB SPI flash programmer with SOIC8 test clip
  4. CH341A USB SPI flash programmer with SOIC8 test clip

CH341A USB Programmer Kit with SOIC8 Clip and 1.8 V Adapter

$11.99

USB programmer for 24-series I2C EEPROMs and 25-series SPI flash, with an SOIC8 test clip and cable, a 1.8 V level adapter, and an SOP8-to-DIP8 socket board. Reads, writes, and backs up flash chips in circuit or in the socket.

Request a Quote
✓Returns: 30-day RMA for unused, sealed catalog hardware. Address is issued after approval. See Returns.
✓Warranty: 90-day limited warranty on paid Kymopsis-branded catalog hardware for manufacturing defects. Custom work follows the quote.
✓Ordering & shipping: Duties and import taxes included: we ship duties paid, so there is nothing extra to pay at delivery. Secure checkout through Stripe. Orders ship worldwide at USD 15, free from a USD 79 merchandise subtotal. Dispatch time is stated on each listing; the carrier is shown at checkout. Policies.
SKU: KYM-DT-CH341A Category:

A low-cost bench programmer for reading and writing SPI NOR flash and I2C EEPROM chips. Use the clip to dump or restore firmware on a board without desoldering the chip.

Specifications

  • Controller: WCH CH341A, USB 2.0
  • Supported chips: 24-series I2C EEPROM and 25-series SPI NOR flash; 93-series with suitable software
  • Voltage: 3.3 V and 5 V; 1.8 V chips through the included adapter
  • Included: CH341A programmer, SOIC8/SOP8 test clip with cable, 1.8 V adapter, SOP8-to-DIP8 adapter board, header pins
  • Software: Open-source flashrom and other CH341A-compatible tools (Windows, Linux, macOS)

Typical uses

  • Backing up and restoring firmware on routers and ESP-class boards
  • Recovering a bricked board from its SPI flash
  • Programming configuration EEPROMs

Check the flash chip voltage first: connect 1.8 V chips only through the 1.8 V adapter. Power the target board off when using the clip in circuit.

Ordering notes

  • Ships within 5 business days after payment.
  • Shipping: USD 15 per order worldwide, free from a USD 79 merchandise subtotal. See Shipping.
  • Need a larger quantity, a different version, or a custom carrier board? Request a quote.

Related products

Kymopsis — RF & mmWave components, radar kits, and engineering services.
Operated by ValueOpus LLC (Wyoming, USA). [email protected]
Contact • Policies • Terms • Privacy • Shipping • Returns • Withdraw from contract • Billing • FAQ • Track order
© 2026 ValueOpus LLC. Regulatory Notice: Radio evaluation hardware is for engineering and laboratory use. It is not a certified consumer radio unless a specific SKU record says so. 47 CFR § 2.803 evaluation-kit treatment is not automatic. See Terms.